No KYC · Non-custodial · Private

SOL/ETH wallet exchange

SOL → ETH (Ethereum mainnet): a privacy-first, non-custodial lane with fees visible before you broadcast. After Solana confirms on Solana mainnet, ToSwap pays ETH out — typically within minutes, not hours.

    Start swap

    You Send
    -
    ▼
    All fees included
    Estimated rate: -
    You Get
    -
    ▼

    Three steps on ToSwap

    1. Set the SOL amount and paste the Ethereum address that should collect payout on Ethereum mainnet.

    2. Tap Exchange to lock the live ToSwap quote and reveal this order’s deposit details.

    3. Send exactly that SOL amount to the deposit. After Solana mainnet confirms, ETH is pushed to your wallet.

    Before you broadcast

    • Solana confirmations are typically fast — often under a minute in practice.
    • Network outages or congestion can occasionally delay inclusion — check status if stuck.
    • Use a Solana mainnet address (base58). Do not send SPL tokens unless the order specifies a token mint.
    • If ETH is late, refresh your wallet and re-check the order status. When a payout hash is already listed, email or SimpleX support with your Exchange ID — ToSwap has no login that can reopen expired pages.
    You send

    Solana on ToSwap — fast L1, still no KYC

    SOL is built for quick, low-cost transfers. Use native Solana addresses on ToSwap unless the order names an SPL mint — privacy-first, quote before you broadcast.

    SOL deposit notes

    Send native SOL on Solana mainnet. Token deposits require the exact asset your order lists.

    Keep a small SOL balance for rent-exempt account requirements in some wallets.

    You receive

    Ethereum on ToSwap — L1 gas, wallet-to-wallet

    ETH settles smart contracts and pays L1 gas. ToSwap routes mainnet ETH without signup: match the L1 badge, leave gas above the swap amount, receive at the address you paste.

    ETH payout not showing?

    Check the order page for a payout transaction hash first.

    Confirm your wallet is on Ethereum mainnet and fully synced.

    ETH payout timing

    Most payouts land within minutes once your deposit confirms — Ethereum blocks are ~12 seconds apart.

    ETH must land on the listed chain

    • Payouts go to Ethereum mainnet — not BSC, Base, Arbitrum, or other L2s unless your order explicitly lists them.
    • Double-check the address you paste: one wrong character sends funds to an unreachable wallet.
    • Self-custody wallets (MetaMask, Rabby, hardware devices) are recommended for long-term holding.

    Float vs fixed rate on ETH payouts

    The rate mode you pick at the top of the swap widget affects how your final ETH amount is calculated.

    • Float rate follows the market until your deposit confirms — best when mempools are quiet.
    • Fixed rate locks the quote for a short window — useful when ETH price is moving quickly.

    Deposit checklist

    Chain mismatches and bad addresses are the usual failure modes — skim these notes before you fund the deposit.

    Send Solana deposits correctly Mainnet SOL, wallet sync, and common first-deposit mistakes. QR scanning tips for deposits Verify scanned addresses against the order text before broadcast. Ethereum gas & gwei for swaps How gas spikes affect deposit cost and confirmation speed. Deposit amount must match exactly Under- and over-payments can delay or fail automated crediting.

    How ToSwap works

    Asset hubs

    More anonymous no-KYC lanes and chain notes for each coin.

    SOL Swap Solana (SOL) — no KYC hub ETH Swap Ethereum (ETH) — no KYC hub

    Other pairs on this route

    ETH → SOL Convert Ethereum to Solana with top rates and low fees where the market allows. No profile, no hosted balance. SOL → BTC Instant Solana → Bitcoin: anonymous no-KYC, wallet-to-wallet, payout after confirmation. SOL → XMR Convert Solana to Monero without an account. No KYC, non-custodial. Live SOL→XMR quote — send from your wallet, receive XMR on ToSwap. SOL → USDT Exchange SOL for USDT without signup — privacy-first, non-custodial, fees shown before you send. SOL → USDT Convert Solana to Tether with top rates and low fees where the market allows. No profile, no hosted balance. SOL → USDC SOL to USDC via ToSwap: fast, secure, no user data stored — paste a receive address and broadcast the deposit. SOL → ZEC Exchange SOL for ZEC without signup — privacy-first, non-custodial, fees shown before you send. SOL → BNB SOL to BNB via ToSwap: fast, secure, no user data stored — paste a receive address and broadcast the deposit. SOL → LTC Convert Solana to Litecoin with top rates and low fees where the market allows. No profile, no hosted balance. SOL → XRP SOL to XRP via ToSwap: fast, secure, no user data stored — paste a receive address and broadcast the deposit. SOL → TRX SOL to TRX via ToSwap: fast, secure, no user data stored — paste a receive address and broadcast the deposit. SOL → DOGE Convert Solana to Dogecoin with top rates and low fees where the market allows. No profile, no hosted balance.

    FAQ for this route

    Is KYC or a ToSwap account required for SOL → ETH?

    No. ToSwap never opens a profile or asks for ID documents on a standard Solana to Ethereum order. You stay non-custodial on both legs.

    How fast does ETH usually arrive?

    Many payouts leave within minutes after the Solana mainnet deposit confirms. Congestion on Solana mainnet or Ethereum mainnet can stretch that — fees and mempools set the clock, not a manual review.

    Does ToSwap hold my SOL or ETH?

    No hosted balance. You broadcast SOL from a wallet you control; ETH is paid only to the address you paste. Nothing sits under a ToSwap username.

    What if I send SOL on the wrong network?

    Match Solana mainnet exactly as printed on the order badge. A wrong-chain deposit often cannot be credited automatically — double-check before you broadcast.