No KYC · Non-custodial · Private

Monero to Ethereum

A fast no-KYC XMR-to-ETH path: the live number is shown first, you fund the deposit from a wallet you control, and payout is automatic on Ethereum mainnet. Nothing sits in a ToSwap balance between the two legs.

    Start swap

    You Send
    -
    ▼
    All fees included
    Estimated rate: -
    You Get
    -
    ▼

    Three steps on ToSwap

    1. Set the XMR amount and paste the Ethereum address that should collect payout on Ethereum mainnet.

    2. Tap Exchange to lock the live ToSwap quote and reveal this order’s deposit details.

    3. Send exactly that XMR amount to the deposit. After Monero mainnet confirms, ETH is pushed to your wallet.

    Before you broadcast

    • Monero needs confirmations before funds are final — wallet sync matters.
    • Give your Monero wallet time to scan new blocks after receipt.
    • Use a fresh subaddress for each swap. Avoid reusing old XMR receive addresses.
    • If ETH is late, refresh your wallet and re-check the order status. When a payout hash is already listed, email or SimpleX support with your Exchange ID — ToSwap has no login that can reopen expired pages.
    You send

    Monero on ToSwap — privacy by default

    XMR hides amounts and destinations on-chain. Prefer a fresh subaddress per ToSwap order; after payout, give your wallet time to scan before you assume the GUI is wrong.

    Keep the Monero wallet synced

    An out-of-sync wallet may not display incoming funds even after the order shows a payout.

    Compare your wallet block height with a public Monero explorer before opening a support ticket.

    You receive

    Ethereum on ToSwap — L1 gas, wallet-to-wallet

    ETH settles smart contracts and pays L1 gas. ToSwap routes mainnet ETH without signup: match the L1 badge, leave gas above the swap amount, receive at the address you paste.

    ETH payout not showing?

    Check the order page for a payout transaction hash first.

    Confirm your wallet is on Ethereum mainnet and fully synced.

    ETH payout timing

    Most payouts land within minutes once your deposit confirms — Ethereum blocks are ~12 seconds apart.

    ETH must land on the listed chain

    • Payouts go to Ethereum mainnet — not BSC, Base, Arbitrum, or other L2s unless your order explicitly lists them.
    • Double-check the address you paste: one wrong character sends funds to an unreachable wallet.
    • Self-custody wallets (MetaMask, Rabby, hardware devices) are recommended for long-term holding.

    Float vs fixed rate on ETH payouts

    The rate mode you pick at the top of the swap widget affects how your final ETH amount is calculated.

    • Float rate follows the market until your deposit confirms — best when mempools are quiet.
    • Fixed rate locks the quote for a short window — useful when ETH price is moving quickly.

    Deposit checklist

    Chain mismatches and bad addresses are the usual failure modes — skim these notes before you fund the deposit.

    Prove a Monero transaction you sent Verify an XMR payment when your wallet is still syncing. Ethereum gas & gwei for swaps How gas spikes affect deposit cost and confirmation speed. Deposit amount must match exactly Under- and over-payments can delay or fail automated crediting. What each swap status means From awaiting deposit to complete — read each status on your order page.

    How ToSwap works

    Asset hubs

    More anonymous no-KYC lanes and chain notes for each coin.

    XMR Swap Monero (XMR) — no KYC hub ETH Swap Ethereum (ETH) — no KYC hub

    Other pairs on this route

    ETH → XMR Exchange ETH for XMR without signup — privacy-first, non-custodial, fees shown before you send. XMR → BTC Exchange XMR for BTC without signup — privacy-first, non-custodial, fees shown before you send. XMR → USDT Convert Monero to Tether with top rates and low fees where the market allows. No profile, no hosted balance. XMR → USDT XMR to USDT via ToSwap: fast, secure, no user data stored — paste a receive address and broadcast the deposit. XMR → USDC Convert Monero to USD Coin with top rates and low fees where the market allows. No profile, no hosted balance. XMR → SOL Convert Monero to Solana with top rates and low fees where the market allows. No profile, no hosted balance. XMR → ZEC Convert Monero to Zcash with top rates and low fees where the market allows. No profile, no hosted balance. XMR → BNB Instant Monero → BNB: anonymous no-KYC, wallet-to-wallet, payout after confirmation. XMR → LTC Move Monero to Litecoin with no KYC. Non-custodial XMR→LTC, fees shown up front, wallet-to-wallet on ToSwap. XMR → XRP Instant Monero → Ripple: anonymous no-KYC, wallet-to-wallet, payout after confirmation. XMR → TRX Instant Monero → Tron: anonymous no-KYC, wallet-to-wallet, payout after confirmation. XMR → DOGE Exchange XMR for DOGE without signup — privacy-first, non-custodial, fees shown before you send.

    FAQ for this route

    Is KYC or a ToSwap account required for XMR → ETH?

    No. ToSwap never opens a profile or asks for ID documents on a standard Monero to Ethereum order. You stay non-custodial on both legs.

    How fast does ETH usually arrive?

    Many payouts leave within minutes after the Monero mainnet deposit confirms. Congestion on Monero mainnet or Ethereum mainnet can stretch that — fees and mempools set the clock, not a manual review.

    Does ToSwap hold my XMR or ETH?

    No hosted balance. You broadcast XMR from a wallet you control; ETH is paid only to the address you paste. Nothing sits under a ToSwap username.

    What if I send XMR on the wrong network?

    Match Monero mainnet exactly as printed on the order badge. A wrong-chain deposit often cannot be credited automatically — double-check before you broadcast.